Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO GT, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, BLIND SPOT (BSM)REMOVAL
2023 Dodge and Ram Durango GT, RWD
Module, Blind Spot (BSM): Removal
2023 Dodge and Ram Durango GT, RWDSECTION Removal
NOTE:
The Blind Spot Module (BSM) mounting brackets are bonded to, and integral to, the back side of the rear bumper fascia.
- Disconnect and isolate the negative battery cable.
- Remove the rear bumper fascia from the vehicle. Refer to FASCIA, REAR, REMOVAL
.
- From the back of the rear fascia, disconnect the wiring harness connector (2) from the BSM.
- Remove the fastener (1) from the right rearward BSM boss location.
- Slide the BSM out of the mounting bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.