Module, Memory Seat (MSM): Removal

2023 Dodge and Ram Durango GT Plus, AWDSECTION Removal
NOTE:

The scan tool standardization process must be performed on the Memory Seat Module (MSM) any time a new MSM is installed, or the existing MSM is updated.

GC0210010Courtesy of CHRYSLER GROUP, LLC
NOTE:

Depending on vehicle options, the amount of MSM wiring harness connectors may differ.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Disconnect the MSM (1) wiring harness connectors (3 and 6).
  3. Disengage the rear MSM retaining tabs (5 and 7) from the bracket (8) by carefully pushing the rear of the MSM upward.
  4. Disengage the front MSM retaining tabs (2 and 4) from the bracket by pulling the MSM rearward.
  5. Remove the MSM from underneath the driver seat.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.