Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Anti-Lock Brake System (Abs): Installation
If the Antilock Brake System (ABS) module is replaced, it must be initialized using the scan tool.
When installing the ABS module to the HCU, be sure to properly align the ABS module and the HCU so that sensor terminals or the contact pads do not touch other parts of the modules. Otherwise, damage to the pressure sensor or Pump Motor connection may result requiring HCU replacement.
- With the ABS module (3) forward of the brake lines (4), move the module toward the outside of the vehicle and around the brake lines in order to align it with the Hydraulic Control Unit (HCU) (1).
- Align the ABS module contact tower (2) to the tower receiving hole of the HCU. Install the ABS module to the HCU without touching the tower terminals to any solenoids.NOTE:
For ease of installation, place the ABS Module Right Hand (RH) bottom retaining fastener into the ABS Module mounting hole, prior to installing the ABS Module onto the HCU.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.