Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSDODGE AND RAM2023CHARGER SXT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (6.4L ENGINE (SERVICE INFORMATION))VALVE TIMINGCHAIN AND SPROCKETS, TIMINGREMOVAL

2023 Dodge and Ram Charger SXT, 4WD

Chain And Sprockets, Timing: Removal

2023 Dodge and Ram Charger SXT, 4WDSECTION Removal

WARNING: This page is about a different variant/trim than selected.

Remove the engine oil pump. Refer to PUMP, ENGINE OIL, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Install the vibration damper bolt finger tight. Using a suitable socket and breaker bar, rotate the crankshaft to align the timing marks with the timing chain sprockets (1, 2).

Courtesy of CHRYSLER GROUP, LLC
Retract the chain tensioner arm (1) until the hole in the arm lines up with the hole in the bracket.

Courtesy of CHRYSLER GROUP, LLC
Install the Tensioner Pin (special tool #8514A, Pins, Tensioner) (1) into the chain tensioner holes.
CAUTION:
Never attempt to disassemble the camshaft phaser, severe engine damage could result.

Courtesy of CHRYSLER GROUP, LLC
Remove the camshaft phaser retaining bolt (1) and remove the timing chain with the camshaft phaser and crankshaft sprocket.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Inspect the timing chain tensioner and timing chain guide shoes for wear and replace as necessary.
If the timing chain tensioner is to be replaced, remove the retaining bolts (3) and remove the timing chain tensioner (2).

Courtesy of CHRYSLER GROUP, LLC
If the timing chain guide (1) is to be replaced, remove the retaining bolts (2) and remove the timing chain guide (1).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.