Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023CHARGER SXT, 4WDREPAIR AND DIAGNOSISBODY & FRAMEFRAMES, SUBFRAMES & CROSSMEMBERSFRAME AND BUMPERSUNDER BODY PROTECTIONBELLY PANINSTALLATION
2023 Dodge and Ram Charger SXT, 4WD
Belly Pan: Installation
2023 Dodge and Ram Charger SXT, 4WDSECTION Installation
NOTE:
Base model shown in the illustration, SRT models similar.
- Position the front belly pan (2) to the underside of the vehicle.
- Install the four push pin fasteners (3) that secure the front belly pan (2) to the underside of the vehicle's lower crossmember.
- Install the eight screws (4) that secure the front belly pan (2) to the underside of the vehicle's front fascia.
- Install the three push pin fasteners (1) that secure the front belly pan (2) to the underside of the vehicle's wheelhouse inner. Repeat for the other side.NOTE:
During installation, ensure rear belly pan is shingled underneath front belly pan. Failure to do so may result in damage to belly pan.
- Position the rear belly pan (1) to the underside of the vehicle and to the front fascia (3).
- Install the fasteners (2) that secure the rear belly pan (1) to the underside of the vehicle. Tighten the fasteners securely.
- Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.