Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023CHARGER R/TREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (1 OF 2)MODULE, INTRUSION TRANSCEIVER (ITM)
2023 Dodge and Ram Charger R/T
Module, Intrusion Transceiver (ITM)
2023 Dodge and Ram Charger R/TSECTION Module, Intrusion Transceiver (ITM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1A3C-00 | INTERNAL SIREN BATTERY |
| B1A20-00 | PRE-ARM TIMEOUT |
| B1A3D-00 | SIREN BATTERY TAMPER / LOSS OF POWER SUPPLY |
| B1A3E-00 | SIREN / ITM MISMATCH |
| B1A3F-00 | ITM ARMING SEQUENCE PERFORMANCE |
| B1A88-92 | ULTRASONIC SENSOR CIRCUIT - PERFORMANCE OR INCORRECT OPERATION |
| B210A-84 | SYSTEM VOLTAGE LOW - SIGNAL BELOW ALLOWABLE RANGE |
| B210B-85 | SYSTEM VOLTAGE LOW - SIGNAL ABOVE ALLOWABLE RANGE |
| B2206-00 | CURRENT VIN MISSING/MISMATCH |
| B222A-00 | VEHICLE LINE MISMATCH |
| B223C-00 | INTRUSION TRANSCEIVER MODULE INTERNAL |
| U0010-00 | CAN INTERIOR BUS |
| U0011-00 | CAN INTERIOR BUS OFF PERFORMANCE |
| U110D-00 | LOST COMMUNICATION WITH SECURITY SIREN |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U0155-00 | LOST COMMUNICATION WITH CLUSTER-CCN |
| U140E-00 | IMPLAUSIBLE VEHICLE CONFIGURATION DATA RECEIVED |
| U1415-00 | IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA |
| U1416 | IMPLAUSIBLE-SECURITY SIREN SIGNAL RECIEVED |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.