Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module And Bracket
2023 Dodge and Ram Charger R/TSECTION Module And Bracket
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Raise and support the vehicle.
- Remove the front fascia from the vehicle. Refer to FASCIA, FRONT, REMOVAL
.
- Disconnect the wiring harness connector (1) from the Adaptive Cruise Control (ACC) module.
- Remove the energy absorber from the vehicle.
- Remove the fasteners (2) securing the mounting bracket (1) to the front bumper support bar.
- Remove the mounting bracket from the front bumper support bar.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.