Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Keyless Ignition Node (Kin): Installation
2023 Dodge and Ram Charger R/TSECTION Installation
NOTE:
Mid Integrated Center Stack (ICS) shown, base similar.
- Push the Keyless Ignition Node (KIN) into the instrument panel until it snaps into place.
- Reach through the ICS screen opening and connect the KIN wire harness connector.
- Install the Instrument Panel Cluster (IPC) bezel (2). Refer to BEZEL, INSTRUMENT CLUSTER, INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.