Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023CHARGER R/TREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, FUEL PUMP CONTROLINSTALLATION
2023 Dodge and Ram Charger R/T
Module, Fuel Pump Control: Installation
2023 Dodge and Ram Charger R/TSECTION Installation
- Position the Fuel Pump Control Module (FPCM) to the right quarter inner panel above and behind the right rear wheel house.
- Securely install the fasteners (1) that secure the FPCM to the right quarter inner panel.
- Connect the body wire harness connector (2) to the FPCM connector receptacle.
- Install the right trunk carpet. Refer to CARPET, INSTALLATION .
- Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.