Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Sensor, Humidity: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.NOTE:
The rearview mirror does not have to be removed to service the humidity sensor.
- Remove the upper and lower rearview mirror trim. Refer to MIRROR, REARVIEW, REMOVAL
.CAUTION:
Use care when removing the humidity sensor. The humidity sensor bracket cannot be serviced separately from the windshield. If the sensor bracket becomes damaged, the windshield will need to be replaced.
- Using a small screwdriver or similar tool, carefully disengage the metal retaining clip (3) from the sensor bracket (2) and remove the humidity sensor (4) and the clip as an assembly.
- Disconnect the wire harness connector (1) from the humidity sensor.
- If the humidity sensor bracket is damaged and cannot be reused, replace the windshield. Refer to WINDSHIELD, REMOVAL and WINDSHIELD, INSTALLATION .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.