Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSDODGE AND RAM2023CHALLENGER SXT, RWDREPAIR AND DIAGNOSISDRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESREAR AXLE - 230RIAINSTALLATION

2023 Dodge and Ram Challenger SXT, RWD

Rear Axle - 230RIA: Installation

2023 Dodge and Ram Challenger SXT, RWDSECTION Installation

Install NEW circlip(s), on the halfshaft(s).

Courtesy of CHRYSLER GROUP, LLC
Install the (special tool #10270, Protector, Half Shaft, Drive) (1) in the rear axle.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Use care when installing halfshaft to axle assembly. The halfshaft installation angle should be minimized to avoid damage to seal upon installation.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.