Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023CHALLENGER SRT SUPER STOCKREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, BODY CONTROL (BCM)INSTALLATION
2023 Dodge and Ram Challenger SRT Super Stock
Module, Body Control (BCM): Installation
2023 Dodge and Ram Challenger SRT Super StockSECTION Installation
- Slide the BCM (4) upper tab(s) to the upper mounting stud(s) and install the lower tabs to the lower mounting studs.
- Install and securely tighten the lower mounting fasteners (3).
- Install and securely tighten the lower mounting fastener(s) (1).
- Connect the BCM wire harness connectors (2).
- Install the glove box assembly. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:
Program the BCM in accordance with the module replacement and programming guide. Refer to IMMOBILIZER COMPONENTS AND REPLACEMENT GUIDE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.