Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Disable/Enable Park Assist Functionality
Park Assist enable and disable routines are available in the scan tool in case of aftermarket bumpers or boxes are installed on the vehicle. There are two routines available, one for each bumper. These routines are located under the "Misc Functions" of the Park Assist Module (PAM). To enable or disable the park assist functionality, select Enable/Disable Front (or Rear) Park Assist Functionality and Diagnostics routines and run the procedure.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.