Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2022DURANGO SXT, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (6.4L FUEL SYSTEM)FUEL INJECTION, GASSENSOR, AIR TEMPERATURE, INTAKEREMOVAL6.4L
2022 Dodge and Ram Durango SXT, AWD
Sensor, Air Temperature, Intake: Removal: 6.4L
2022 Dodge and Ram Durango SXT, AWDSECTION 6.4L
WARNING: This page is about a different variant/trim than selected.
The Intake Air Temperature (IAT) sensor (4) is installed into the air cleaner duct (3).
- Disconnect the electrical connector at the IAT sensor (4).
- Gently lift on the small plastic release tab and rotate the IAT sensor about 1/4 turn counter-clockwise and remove.
- Check condition of sensor O-ring, replace if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.