Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
When Monitored
2022 Dodge and Ram Durango SXT, AWDSECTION When Monitored
WARNING: This page is about a different variant/trim than selected.
This diagnostic runs continuously when the following conditions are met:
- With the engine running.
- PCM must see engine speed over 400 RPM for minimum time of 10 seconds. This prevents a fault on an engine start/stall condition.
- Fuel level is greater then 5%.
- The PCM did not request an ESS Auto-stop event.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.