Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test
2022 Dodge and Ram Durango SXT, AWDSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR POWERTRAIN CONTROL MODULE (PCM) DTCS
- With the scan tool, read PCM DTCs.
Are there any other PCM DTCs present?
Yes
- Perform the applicable diagnostic procedure(s) for the other PCM DTC(s). Refer to DTC INDEX .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- Go To 2
- With the scan tool, read PCM DTCs.
- CHECK FOR ANY SERVICE BULLETINS OR PCM SOFTWARE UPDATES
- Check for any applicable Service Bulletins, Star On-line Cases or Flash updates related to the DTC or stall condition.
Are there any applicable Service Bulletins, Star On-line Cases or Flash updates?
Yes
- Perform the applicable repair.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- Perform the START AND STALL CONDITION test procedure. The START AND STALL CONDITION test procedure lists several possible causes for a stall condition. This is a general list to help give direction where to look for an issue that can cause a stall. If the vehicle is setting this DTC alone with no other faults do not overlook possible intermittent circuit issues for any component or system that can cause an engine to intermittently stall. An intermittent stall event is most likely not going to be caused by an engine mechanical part issue affecting the engine combustion. Focus on electrical issues for components that can affect spark or fueling and perform the INTERMITTENT CONDITION test procedure. Refer to INTERMITTENT CONDITION .
- Check for any applicable Service Bulletins, Star On-line Cases or Flash updates related to the DTC or stall condition.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.