Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020DURANGO GT, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 17 (5.7L - DTCS P0175 TO P050B)DTC TROUBLESHOOTINGP0440-GENERAL EVAP SYSTEM FAILUREPOSSIBLE CAUSES
2020 Dodge and Ram Durango GT, AWD
Possible Causes
2020 Dodge and Ram Durango GT, AWDSECTION Possible Causes
WARNING: This page is about a different variant/trim than selected.
| Possible Causes |
|---|
| EVAP PURGE SOLENOID VACUUM SUPPLY |
| EVAP PURGE TUBE OBSTRUCTION |
| OBSTRUCTION IN THE VENT HOSE OR FILTER |
| ESIM ORIENTATION OR INSTALLED INCORRECTLY |
| LARGE EVAPORATIVE EMISSION LEAK |
| ESIM SIGNAL CIRCUIT OPEN |
| ESIM GROUND CIRCUIT OPEN |
| EVAPORATIVE SYSTEM INTEGRITY MONITOR (ESIM) SWITCH STUCK OPEN |
| EVAP PURGE SOLENOID |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.