SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020DURANGO GT, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 13 (5.7L FUEL SYSTEM)FUEL INJECTION, GASPEDAL, ACCELERATORINSTALLATION
2020 Dodge and Ram Durango GT, AWD

Pedal, Accelerator: Installation

2020 Dodge and Ram Durango GT, AWDSECTION Installation
WARNING: This page is about a different variant/trim than selected.
GC0190453Courtesy of CHRYSLER GROUP, LLC

The Accelerator Pedal Position Sensor (APPS) and the accelerator pedal is serviced as a complete assembly including the bracket.

  1. Position the accelerator pedal assembly onto the two mounting studs.
  2. Install the three accelerator pedal retaining bracket nuts (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
  3. Connect the accelerator pedal electrical connector (2) to the APPS.
  4. Use a scan tool to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.
  5. If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.
  6. If necessary, also use a scan tool to erase any Diagnostic Trouble Codes (DTC's) from the PCM.
  7. Before starting the engine, operate the accelerator pedal to check for any binding.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.