Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020DURANGO GT, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 11 (6.4L ENGINE (SERVICE INFORMATION))AIR INTAKE SYSTEMBODY, AIR CLEANERINSTALLATION
2020 Dodge and Ram Durango GT, AWD
Body, Air Cleaner: Installation
2020 Dodge and Ram Durango GT, AWDSECTION Installation
WARNING: This page is about a different variant/trim than selected.
- If removed, install the air duct (3) to the air cleaner housing (1).
- While sliding the air duct onto the throttle body, lower the air cleaner housing into position and align the locating pins on the bottom of the housing.
- Install the makeup air hose (5) at the air cleaner housing.
- Connect the intake air temperature sensor electrical connector (4).
- Position the air duct retaining clamps (2) at the throttle body and air duct. Tighten to 3 N.m (30 in. lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.