Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020DURANGO GT, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, KEYLESS IGNITION NODE (KIN)INSTALLATION
2020 Dodge and Ram Durango GT, AWD
Module, Keyless Ignition Node (Kin): Installation
2020 Dodge and Ram Durango GT, AWDSECTION Installation
- Align the KIN to the instrument panel bezel allowing the retaining tabs (1) to secure the KIN in position.
- Connect the electrical connector (1) to the KIN.
- Place the steering column gap hider back to its installed position, engaging all the snap clips.
- If the KIN is being replaced, perform the RFHM verification test. Refer to RADIO FREQUENCY HUB (RF HUB) VERIFICATION TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.