Switch, Speed Control: Installation

2020 Dodge and Ram Durango GT, AWDSECTION Installation
WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

GC0190442Courtesy of CHRYSLER GROUP, LLC
  1. Position the Speed Control switch pods (3) into the steering wheel armature.
  2. Install and tighten the screws (2) that secures the switches to the front of the steering wheel armature and connect the wire harness connectors (1).
    GC0190433Courtesy of CHRYSLER GROUP, LLC
  3. Install and tighten the screws (1) in the back of the steering wheel to the switches.
  4. Install the remote radio switch. Refer to SWITCH, REMOTE RADIO, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.