Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020DURANGO GT, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESNAVIGATION/TELECOMMUNICATION (SERVICE INFORMATION)ANTENNA, LONG-TERM EVOLUTION 2 (LTE2)REMOVAL
2020 Dodge and Ram Durango GT, AWD
Antenna, Long-Term Evolution 2 (LTE2): Removal
2020 Dodge and Ram Durango GT, AWDSECTION Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the radio. Refer to RADIO, REMOVAL
.
- Remove the two retainer clips (1) securing the Long Term Evolution 2 (LTE2) antenna (2) to the instrument panel carrier and remove LTE2 from instrument panel.
- If replacing the LTE2 antenna or LTE2 antenna jumper cable, disconnect the jumper cable from the LTE2 antenna.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.