Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020DURANGO GT, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, FORWARD FACING CAMERA (FFCM)REMOVAL
2020 Dodge and Ram Durango GT, AWD
Module, Forward Facing Camera (FFCM): Removal
2020 Dodge and Ram Durango GT, AWDSECTION Removal
multimedia:A supplement to the article is available.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Separate the rear view mirror trim covers to gain access to the Forward Facing Camera Module (FFCM) (2) .
- Disconnect the FFCM wire harness connector (1).
- The FFCM is attached to the windshield bracket in a hook and rotate manner. Rotate the FFCM downwards to disengage the windshield bracket hooks and release the FFCM from the bracket. It is easier to remove the FFCM from the passenger seat.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.