Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020DURANGO GT, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, ELECTRONIC SHIFT (ESM)INSTALLATION
2020 Dodge and Ram Durango GT, AWD
Module, Electronic Shift (ESM): Installation
2020 Dodge and Ram Durango GT, AWDSECTION Installation
- Position the Electronic Shift Module (ESM) in place and connect the wire harness connector (1).
- Install the fasteners (1) and tighten to the proper specifications. Refer to the appropriate Transmission Service Information.
- Install the shifter bezel. Refer to BEZEL, SHIFTER, INSTALLATION .
- Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.