Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2020CHALLENGER GT, 4WDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTSEATSPOWER SEATS (SERVICE INFORMATION)SWITCH, LUMBAR CONTROLINSTALLATION
2020 Dodge and Ram Challenger GT, 4WD
Switch, Lumbar Control: Installation
2020 Dodge and Ram Challenger GT, 4WDSECTION Installation
NOTE:
Driver seat shown in illustration. Passenger seat similar.
- Connect the electrical connector (3) to the power lumbar control switch (1).
- Position the lumbar control switch to the seat cushion side trim panel (5) and engage the four retaining tabs (2 and 4).
- Position the side shield (2) slightly forward and push down to engage the top retaining clips (1), then push rearward to engage the front retaining clip (5).
- Push at the bottom to engage the retaining clips (4).
- Install the screw (3) at the back of the side shield. Tighten the screw securely.
- Fasten the lower straps for the seat back panel.
- Install the trim cover over the seat belt anchor.
- Connect the negative battery cable.
- Verify proper power lumbar support operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.