Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM20162500 HD LIMITED, 4D PICKUP, 6.4L ENG VIN J, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEX - 2500 HD & 3500 HDMODULE, VEHICLE SYSTEM INTERFACE (VSIM)
2016 Dodge and Ram 2500 HD Limited, 4D Pickup, 6.4L Eng VIN J, 4WD
Module, Vehicle System Interface (VSIM)
2016 Dodge and Ram 2500 HD Limited, 4D Pickup, 6.4L Eng VIN J, 4WDSECTION Module, Vehicle System Interface (VSIM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B0050-11 | DRIVER SEATBELT SENSOR-CIRCUIT SHORT TO GROUND |
| B1612-12 | PANEL ILLUMINATION CONTROL - CIRCUIT SHORT TO BATTERY |
| B2103-11 | IGNITION RUN/START 1 CONTROL - CIRCUIT SHORT TO GROUND |
| B2199-12 | BATTERY VOLTAGE - CIRCUIT SHORT TO BATTERY |
| B2253-11 | HOWLER SIREN - CIRCUIT SHORT TO GROUND |
| B22A9-00 | ECU INTERNAL PERFORMANCE |
| B287B-12 | LEFT REAR WIG WAG LIGHTS - CIRCUIT SHORT TO BATTERY |
| B287C-12 | RIGHT REAR WIG WAG LIGHTS - CIRCUIT SHORT TO BATTERY |
| P1E16-11 | DIESEL REGEN ACTIVE - CIRCUIT SHORT TO GROUND |
| P1E16-12 | DIESEL REGEN ACTIVE - CIRCUIT SHORT TO BATTERY |
| P1E1E-00 | POSITIVE ENGAGEMENT SWITCH CIRCUIT SHORTED TO GROUND |
| P1E1F-00 | PTO PRESSURE SWITCH CIRCUIT SHORT TO GROUND |
| U0064-00 | VSIM UPFITTER BUS |
| U0065-00 | VSIM UPFITTER BUS OFF PERFORMANCE |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.