Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 ((POWERTRAIN CONTROL MODULE (PCM) - ELECTRICAL DIAGNOSTICS - 41TE AUTOMATIC TRANSMISSION))DTC TROUBLESHOOTINGP1790-FAULT IMMEDIATELY AFTER SHIFTDIAGNOSTIC TEST
2013 Dodge and Ram Journey Crew, AWD
Diagnostic Test
2013 Dodge and Ram Journey Crew, AWDSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- FAULT AFTER SHIFT
- This DTC is set along with a Gear Ratio DTC. Perform the appropriate test for the Gear Ratio DTC stored.NOTE:
Check Pending DTCs or 1 trip failures if there are no Active or Stored Gear Ratio DTCs.
Repair
- Refer to the DTC INDEX and perform the appropriate diagnostic procedure.
- Perform 40/41TE VERIFICATION TEST. Refer to 40/41 TE TRANSMISSION VERIFICATION TEST .
- This DTC is set along with a Gear Ratio DTC. Perform the appropriate test for the Gear Ratio DTC stored.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.