SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 ((POWERTRAIN CONTROL MODULE (PCM) - ELECTRICAL DIAGNOSTICS - 41TE AUTOMATIC TRANSMISSION))DTC TROUBLESHOOTINGP0765-UD SOLENOID CIRCUITDIAGNOSTIC TEST
2013 Dodge and Ram Journey Crew, AWD

Diagnostic Test

2013 Dodge and Ram Journey Crew, AWDSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
  1. CHECK FOR RELATED DTCS 
    1. With the scan tool, read DTCs

      Are there any Transmission Control Relay or TCM Power Input DTCs present also?

      Yes 

      • Refer to the DTC INDEX and perform the appropriate diagnostic procedure.

      No 

      • Go To  2
  2. CHECK IF THE DTC IS CURRENT 
    1. With the scan tool, read DTCs.

      Is the status Active or is the Starts Since Set counter set at 0 for this DTC?

      Yes 

      • Go To  3

      No 

      • Go To  7
  3. CHECK THE PCM AND WIRING USING THE TRANSMISSION SIMULATOR 
    1. Turn the ignition off to the lock position.
    2. Remove the Starter Relay.
      CAUTION:

      Removal of the Starter Relay will prevent the vehicle from being started in gear.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.