Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 ((POWERTRAIN CONTROL MODULE (PCM) - ELECTRICAL DIAGNOSTICS - 41TE AUTOMATIC TRANSMISSION))DTC TROUBLESHOOTINGP0733-GEAR RATIO ERROR IN 3RDPOSSIBLE CAUSES
2013 Dodge and Ram Journey Crew, AWD
Possible Causes
2013 Dodge and Ram Journey Crew, AWDSECTION Possible Causes
WARNING: This page is about a different variant/trim than selected.
| Possible Causes |
|---|
| RELATED TRANSMISSION DTCS PRESENT |
| INPUT OR OUTPUT SPEED SENSOR ERRORS |
| LOW LINE PRESSURE |
| FAILED UD OR OD CLUTCH |
| CUT OR TORN UD OR OD CLUTCH PISTON SEAL |
| CUT UD OR OD ACCUMULATOR PISTON SEAL |
| STUCK MAIN REGULATOR VALVE |
| SOLENOID MODULE |
| BROKEN INPUT SHAFT |
| FAILED UD SHAFT |
| FAILED OD SHAFT |
| FAILED REAR PLANETARY GEARSET |
| FAILED FRONT CARRIER |
| FAILED REAR ANNULUS SHELL/SNAP RINGS |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Refer to 40/41TE PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.