Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 ((POWERTRAIN CONTROL MODULE (PCM) - ELECTRICAL DIAGNOSTICS - 41TE AUTOMATIC TRANSMISSION))DTC TROUBLESHOOTINGP0716-INPUT SPEED SENSOR 1 CIRCUIT PERFORMANCEDIAGNOSTIC TEST

2013 Dodge and Ram Journey Crew, AWD

Diagnostic Test

2013 Dodge and Ram Journey Crew, AWDSECTION Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK TO SEE IF DTC P0716 IS CURRENT
1. Start the engine.
2. Place the shift lever in park.
3. With the scan tool, read the Input Speed Sensor rpm.
  Is the Input Speed Sensor reading below 400 rpm?
  
  Yes
  - Go To 2
  No
  - Go To 8
CHECK THE PCM AND WIRING WITH THE TRANSMISSION SIMULATOR
1. Turn the ignition off to the lock position.
2. Remove the Starter Relay.
  CAUTION:
  Removal of the Starter Relay will prevent the vehicle from being started in gear.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.