Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (2.4L - DTCS P0457 TO P1C4E)DIAGNOSIS AND TESTINGP0463-FUEL LEVEL SENSOR 1 CIRCUIT HIGHSET CONDITION
2013 Dodge and Ram Journey Crew, AWD
Set Condition
2013 Dodge and Ram Journey Crew, AWDSECTION Set Condition
WARNING: This page is about a different variant/trim than selected.
The fuel level sensor signal voltage at the Powertrain Control Module (PCM) goes above the maximum acceptable value. One Trip Fault. Three good trips to turn off the MIL.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.