Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 93 (DTC INDEX)CLUSTER, INSTRUMENT
2013 Dodge and Ram Journey Crew, AWD
Cluster, Instrument
2013 Dodge and Ram Journey Crew, AWDSECTION Cluster, Instrument
WARNING: This page is about a different car, the 2012 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B21DD-84 | SYSTEM VOLTAGE-SIGNAL BELOW ALLOWABLE RANGE |
| B21DD-85 | SYSTEM VOLTAGE-SIGNAL VOLTAGE ABOVE ALLOWABLE RANGE |
| U0001-00 | CAN C BUS |
| U0002-00 | CAN C BUS OFF PERFORMANCE |
| U0100-00 | LOST COMMUNICATION WITH PCM |
| U0101-00 | LOST COMMUNICATION WITH TCM |
| U0114-00 | LOST COMMUNICATION WITH FINAL DRIVE CONTROL MODULE |
| U0121-00 | LOST COMMUNICATION WITH ANTI-LOCK BRAKE SYSTEM (ABS) CONTROL MODULE |
| U0127-00 | LOST COMMUNICATION WITH TIRE PRESSURE MONITOR MODULE |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U0151-00 | LOST COMMUNICATION WITH OCCUPANT RESTRAINT CONTROLLER (ORC) |
| U0159-00 | LOST COMMUNICATION WITH PARK ASSIST CONTROL MODULE (PTS) |
| U0212-00 | LOST COMMUNICATION WITH SCM |
| U11B9-00 | LOST COMMUNICATION WITH RF HUB |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.