Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 73 (INTRUSION TRANSCEIVER MODULE (ITM) - ELECTRICAL DIAGNOSTICS)DTC TROUBLESHOOTINGU140E-00-IMPLAUSIBLE VEHICLE CONFIGURATION DATA RECEIVEDDIAGNOSTIC TEST
2013 Dodge and Ram Journey Crew, AWD
Diagnostic Test
2013 Dodge and Ram Journey Crew, AWDSECTION Diagnostic Test
WARNING: This page is about a different car, the 2012 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
- Turn the ignition on.
- With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 2.
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CAN BUS DTCS SET IN BODY CONTROL MODULE (BCM) NOTE:
Verify that the BCM has the correct vehicle configuration before proceeding with this test step.
- With the scan tool, read DTCs in the BCM.
Are there any active CAN Bus DTCs present?
Yes
- Refer to BODY CONTROL MODULE (BCM) - DTCS B10B3-14 TO B182C-13 or BODY CONTROL MODULE (BCM) - DTCS B1830-11 TO U1433-24 and perform the appropriate diagnostic procedure.
No
- Replace the ITM in accordance with the Service Information. Refer to MODULE, INTRUSION, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- With the scan tool, read DTCs in the BCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.