Diagnostic Code Index

2013 Dodge and Ram Journey Crew, AWDSECTION Diagnostic Code Index
WARNING: This page is about a different car, the 2012 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC CODE INDEX

DTC Description
B143A-13  MICROPHONE 1 - CIRCUIT OPEN
B143A  B143A 92 MICROPHONE 1 - PERFORMANCE OR INCORRECT OPERATION
B143D  13 MICROPHONE 2 - CIRCUIT OPEN
B143D  B143D 92 MICROPHONE 2 - PERFORMANCE OR INCORRECT OPERATION
B155C  11 MICROPHONE 1 CIRCUIT (+) - CIRCUIT SHORT TO GROUND
B155C  12 MICROPHONE 1 CIRCUIT (+) - CIRCUIT SHORT TO BATTERY
B155D  11 MICROPHONE 1 CIRCUIT (-) - CIRCUIT SHORT TO GROUND
B155D-12  MICROPHONE 1 CIRCUIT (-) - CIRCUIT SHORT TO BATTERY
B155E-11  MICROPHONE 2 CIRCUIT (+) - CIRCUIT SHORT TO GROUND
B155E-12  MICROPHONE 2 CIRCUIT (+) - CIRCUIT SHORT TO BATTERY
B155F-11  MICROPHONE 2 CIRCUIT (-) - CIRCUIT SHORT TO GROUND
B155F-12  MICROPHONE 2 CIRCUIT (-) - CIRCUIT SHORT TO BATTERY
B2199-16  BATTERY VOLTAGE - CIRCUIT VOLTAGE BELOW THRESHOLD
B2199-17  BATTERY VOLTAGE - CIRCUIT VOLTAGE ABOVE THRESHOLD
B2223-00  (HFM) HANDS FREE PHONE INTERNAL
U0147-00  LOST COMMUNICATION WITH TELEMATICS GATEWAY
U0186-00  LOST COMMUNICATION WITH AUDIO AMPLIFIER
U0196-00  LOST COMMUNICATION WITH VEHICLE ENTERTAINMENT CONTROL MODULE - REAR 1
U103A  00 CAN-AT (AUDIO AND TELEMATICS) BUS
U103A  92 CAN AT (AUDIO AND TELEMATICS) BUS PERFORMANCE OR INCORRECT OPERATION
U11B8  00 LOST COMMUNICATION WITH INTEGRATED CENTER STACK (ICS)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.