Diagnostic Test

2013 Dodge and Ram Journey Crew, AWDSECTION Diagnostic Test
WARNING: This page is about a different car, the 2012 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
  1. INTEGRATED CENTER STACK (ICS) SCREEN MODULE HIGH TEMPERATURE 
    1. Turn the ignition on.
    2. With the scan tool, clear all ICS DTCs.
    3. Turn the ICS on.
    4. With the scan tool, read the DTC information.

      Does the scan tool read: B156E-4B INTEGRATED CENTER STACK (ICS)- OVER TEMPERATURE as active?

      Yes 

      • Turn the Integrated Center Stack (ICS) Screen Module off and allow the unit to cool.
      • Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.

      No 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.