SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 51 (RADIO FREQUENCY (RF HUB) MODULE - ELECTRICAL DIAGNOSTICS)DTC TROUBLESHOOTINGB1A09-00-RKE FOB 2 PERFORMANCEDIAGNOSTIC TEST
2013 Dodge and Ram Journey Crew, AWD

Diagnostic Test

2013 Dodge and Ram Journey Crew, AWDSECTION Diagnostic Test
WARNING: This page is about a different car, the 2012 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
  1. TEST FOR INTERMITTENT CONDITION 
    NOTE:

    All FOBIKs used with this vehicle should be present during this test.

    1. With one of the owners good FOBIKs, turn the ignition on.
    2. With the scan tool, record and erase the DTCs.
    3. Operate the alleged inoperative FOBIK in all positions several times.
    4. With the scan tool, read the DTCs.

      Does the scan tool display this DTC as active?

      Yes 

      • Go To  2.

      No 

      • The conditions that caused this code to set are not present at this time. The FOBIK may have already been re-syncronized by being in the vehicle while it was being driven. Inform the owner of the most probable cause for this code to set and therefore causing the FOBIK to be inoperative.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. TEST DRIVE THE VEHICLE 
    1. With the scan tool, erase the DTCs.
    2. Turn the ignition off.
    3. Put the inoperative FOBIK in the vehicle.
    4. With the good FOBIK, start and drive the vehicle above five miles per hour for one mile.
    5. Turn the ignition off.
    6. Operate the inoperative FOBIK in all positions several times.
    7. With the scan tool, read the DTCs.

      Does the scan tool display this DTC as active?

      Yes 

      • Replace the FOBIK and program using the scan tool.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.