Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 25 (ENGINE COOLING SYSTEM)ENGINEPUMP, WATERINSTALLATION2.4L ENGINE
2013 Dodge and Ram Journey Crew, AWD
2.4L Engine
2013 Dodge and Ram Journey Crew, AWDSECTION 2.4L Engine
WARNING: This page is about a different car, the 2012 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - WATER PUMP |
| 2 - MOUNTING BOLT |
| 3 - WATER INLET TUBE NUTS |
| 4 - INLET WATER TUBE |
- Position water pump assembly (1) and gasket onto cylinder block.
- Position water inlet tube (4) and gasket onto water pump (1).
- Install mounting bolts (2). Tighten bolts to 25.5 N.m (225 in. lbs.).
- Install drive belt splash shield.
- Lower vehicle.
- Install accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
- Evacuate air and refill cooling system. Refer to PUMP, WATER, STANDARD PROCEDURE .
- Check cooling system for leaks. Refer to DIAGNOSIS AND TESTING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.