Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMFUEL DELIVERY, GASFITTING, QUICK CONNECTSTANDARD PROCEDURESTANDARD PROCEDURE - QUICK-CONNECT FITTINGSCONNECTING
2013 Dodge and Ram Journey Crew, AWD
Standard Procedure - Quick-Connect Fittings: Connecting
2013 Dodge and Ram Journey Crew, AWDSECTION Connecting
- Inspect the quick-connect fitting body and fuel system components for damage. Replace as necessary.
- Prior to connecting any quick-connect fitting to components, check condition of fitting and components. Clean parts with a lint-free cloth. Lubricate with clean engine oil.
- Insert the quick-connect fitting onto the fuel tube or fuel system component until the built-in stop on the fuel tube or component rests against the back of fitting.
- Continue pushing until a click is felt.
- If Equipped:
- Redundant Latch Single Button Type Fitting: Push redundant latch until it locks into position in the quick-connect fitting.
- Single Tab Type Fitting: Push new tab down until it locks into position in the quick-connect fitting.
- Latch Clip Type Fitting: Install latch clip (snaps into position). If latch clip will not snap into position, this indicates the quick-connect fitting is not properly installed onto fuel system component, recheck the connection.
- Verify a locked condition by firmly pulling on the quick-connect fitting connection of the fuel system component.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.