SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISENGINE MECHANICALEXHAUST SYSTEMPIPE, EXHAUST CROSSUNDERINSTALLATION2.0L DIESEL
2013 Dodge and Ram Journey Crew, AWD

2.0L Diesel

2013 Dodge and Ram Journey Crew, AWDSECTION 2.0L Diesel
Fig 1: DPF Flange, Gasket, Exhaust Crossunder Pipe & Fasteners
GC0147567Courtesy of CHRYSLER GROUP, LLC
  1. Position new gasket (3) onto the diesel particulate filter (DPF) flange (2).
  2. Position the cross-under pipe (5) into its position onto the DPF flange (2).
  3. Install the front flange mounting nuts (4). Tighten nuts to 27 N.m (250 in. lbs.).
  4. Install the rear flange bolt (5). Tighten bolt to 30 N.m (22 ft. lbs.).
    Fig 2: Clamp, Down Pipe & Cross-Under Pipe
    GC0147844Courtesy of CHRYSLER GROUP, LLC
  5. Install the down pipe (1) onto the cross-under pipe (3). Tighten the pipe clamp (2) to 50 N.m (37 ft. lbs.).
  6. Check for clearance of the exhaust to body.
    Fig 3: Engine Belly Pan & Fasteners
    GC0147566Courtesy of CHRYSLER GROUP, LLC
  7. If equipped, install the lower engine bellypan shield.
  8. Lower the vehicle.
  9. Connect the negative battery cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.