SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTTELEMATICS GATEWAY MODULE - ELECTRICAL DIAGNOSTICSDTC TROUBLESHOOTINGB223B-00-VEHICLE CONFIGURATION MISMATCHDIAGNOSTIC TEST
2013 Dodge and Ram Journey Crew, AWD

Diagnostic Test

2013 Dodge and Ram Journey Crew, AWDSECTION Diagnostic Test
  1. CHECK FOR ACTIVE DTC 
    1. Turn the ignition on.
    2. With the scan tool, record and erase the Hands Free Module DTCs.
    3. Cycle the ignition switch from on to off, wait five seconds and then back to on.
    4. With the scan tool, read the active Hands Free Module DTCs.

      Does the scan tool display this DTC as active?

      Yes 

      • Locate the incorrect component and replace as needed
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.