Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, TELEMATICS GATEWAYREMOVALREMOVAL

2013 Dodge and Ram Journey Crew, AWD

Module, Telematics Gateway: Removal: Removal

2013 Dodge and Ram Journey Crew, AWDSECTION Removal

Fig 1: Bezel Assembly

Courtesy of CHRYSLER GROUP, LLC

Perform a complete backup of user data. Refer to STANDARD PROCEDURE .
Disconnect the negative battery cable.
Remove the switch-bank and bezel assembly (1). Refer to POD, SWITCH BANK, REMOVAL .

Fig 2: Retainers & Telematics Gateway Module (TGM)
Courtesy of CHRYSLER GROUP, LLC
Remove the retainers (1) from the Telematics Gateway Module (TGM) (2) and pull out far enough to access the connectors on the back of the TGM.

Fig 3: Antenna(s), Video Cable, RF HUB, Wiring Connectors And UCI Cables
Courtesy of CHRYSLER GROUP, LLC

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.