Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE, KEYLESS IGNITION NODEREMOVALREMOVAL
2013 Dodge and Ram Journey Crew, AWD
Module, Keyless Ignition Node: Removal: Removal
2013 Dodge and Ram Journey Crew, AWDSECTION Removal
- Disconnect the negative battery cable.
- Remove the switch-bank and bezel assembly (1). Refer to POD, SWITCH BANK, REMOVAL .
- Remove the instrument panel center bezel (1). Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
- Disconnect the wire connector (1) from the Keyless Ignition Node (KIN).
- Push down on the release clips (2) (two on top and one on the bottom) and push the KIN (3) out the front of the instrument panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.