Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXMODULE, INTEGRATED CENTER STACK/SCREEN
2013 Dodge and Ram Journey Crew, AWD
Module, Integrated Center Stack/Screen
2013 Dodge and Ram Journey Crew, AWDSECTION Module, Integrated Center Stack/Screen
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B11E7-00 | HVAC SWITCH BANK DISCONNECTED |
| B11E8-2A | HVAC/AUDIO LOWER SWITCH BANK BUTTON(S) STUCK |
| B156C-2A | CENTER STACK SWITCH BANK BUTTON(S) STUCK |
| B156D-00 | LOW VOLTAGE DIFFERENTIAL SIGNAL (LVDS) VIDEO CABLE |
| B156E-4B | INTEGRATED CENTER STACK (ICS) - OVER TEMPERATURE |
| B210D-16 | BATTERY VOLTAGE LOW - CIRCUIT VOLTAGE BELOW THRESHOLD |
| B210E-17 | BATTERY VOLTAGE HIGH - CIRCUIT VOLTAGE ABOVE THRESHOLD |
| U0147-00 | LOST COMMUNICATION WITH TELEMATICS GATEWAY |
| U0186-00 | LOST COMMUNICATION WITH AUDIO AMPLIFIER |
| U0196-00 | LOST COMMUNICATION WITH VEHICLE ENTERTAINMENT CONTROL MODULE - REAR 1 |
| U0197-00 | LOST COMMUNICATION WITH HANDS FREE PHONE MODULE |
| U103A-92 | CAN AT (AUDIO AND TELEMATICS) BUS PERFORMANCE OR INCORRECT OPERATION |
| U103A-00 | CAN-AT (AUDIO AND TELEMATICS) BUS |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.