Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013JOURNEY CREW, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXMODULE, DRIVETRAIN CONTROL (DTCM)
2013 Dodge and Ram Journey Crew, AWD
Module, Drivetrain Control (DTCM)
2013 Dodge and Ram Journey Crew, AWDSECTION Module, Drivetrain Control (DTCM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| C1078 | TIRE REVOLUTIONS RANGE PERFORMANCE |
| C1456 | AWD CLUTCH POWER CONTROL CIRCUIT LOW |
| C145D | AWD CLUTCH POWER/RETURN CONTROL CIRCUIT OPEN |
| C145F | AWD SYSTEM TEMPORARILY DISABLED - OVERTEMPERATURE |
| C2100 | BATTERY VOLTAGE LOW |
| C2101 | BATTERY VOLTAGE HIGH |
| C211C | IGNITION RUN/START INPUT CIRCUIT LOW |
| C211D | IGNITION RUN/START INPUT CIRCUIT HIGH |
| C2201 | FDCM/DTCM INTERNAL |
| C2206 | VEHICLE CONFIGURATION MISMATCH |
| U0001 | CAN C BUS |
| U0100 | LOST COMMUNICATION WITH THE ECM/PCM |
| U0121 | LOST COMMUNICATION WITH ABS |
| U0126 | LOST COMMUNICATION WITH STEERING ANGLE SENSOR (SCM) |
| U0141 | LOST COMMUNICATION WITH IPM (BCM) |
| U0401 | IMPLAUSIBLE DATA RECEIVED FROM ECM/PCM |
| U1415 | IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION RECEIVED |
| U113C | LOST WHEEL SPEED MESSAGES |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.