Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013DART GTREPAIR AND DIAGNOSISGENERAL INFORMATIONDTC INDEXMODULE, ELECTRONIC SHIFT (ESM)
2013 Dodge and Ram Dart GT
Module, Electronic Shift (ESM)
2013 Dodge and Ram Dart GTSECTION Module, Electronic Shift (ESM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| P0607-29 | ECU INTERNAL PERFORMANCE-SIGNAL INVALID |
| P0607-42 | ECU INTERNAL PERFORMANCE-GENERAL MEMORY FAILURE |
| P0607-44 | ECU INTERNAL PERFORMANCE-DATA MEMORY FAILURE |
| P0607-45 | ECU INTERNAL PERFORMANCE-PROGRAM MEMORY FAILURE |
| P0607-47 | ECU INTERNAL PERFORMANCE-WATCHDOG/SAFETY FAILURE |
| P0607-48 | ECU INTERNAL PERFORMANCE-SUPERVISION SOFTWARE FAILURE |
| P0607-62 | ECU INTERNAL PERFORMANCE-SIGNAL COMPARE FAILURE |
| P0826-01 | UP/DOWN SHIFT SWITCH-GENERAL ELECTRICAL FAILURE |
| P1C86-1D | PRNDL DISPLAY-CIRCUIT CURRENT OUT OF RANGE |
| P1C86-82 | PRNDL DISPLAY-ALIVE/SEQUENCE COUNTER INCORRECT/NOT UPDATED |
| P1C86-83 | PRNDL DISPLAY-VALUE OF SIGNAL PROTECTION CALCULATION INCORRECT |
| P1C86-92 | PRNDL DISPLAY-PERFORMANCE OR INCORRECT OPERATION |
| U0002-00 | CAN C BUS OFF PERFORMANCE |
| U0100-00 | LOST COMMUNICATION WITH ECM/PCM |
| U0101-00 | LOST COMMUNICATION WITH TCM |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.