Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013DART GTREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 15 ((TRANSMISSION CONTROL MODULE (TCM) - ELECTRICAL DIAGNOSTICS - 6F24 AUTOMATIC TRANSMISSION))DTC TROUBLESHOOTINGU0415-IMPLAUSIBLE DATA RECEIVED FROM ABSDIAGNOSTIC TEST
2013 Dodge and Ram Dart GT
Diagnostic Test
2013 Dodge and Ram Dart GTSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR BCM CAN BUS DTCS
- With the scan tool, read BCM DTCs.
Are any BCM CAN BUS DTCs present?
Yes
- Refer to the DTC INDEX and perform the appropriate diagnostic procedure. Perform the diagnostic procedure for DTC U0001-CAN C BUS first if the fault is present.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to 6F24 TRANSMISSION VERIFICATION TEST .
No
- Go To 2
- With the scan tool, read BCM DTCs.
- ANTI-LOCK BRAKE MODULE (ABS) DTCS PRESENT
- With the scan tool, read ABS DTCs.
Are any ABS DTCs present?
Yes
- Refer to the DTC INDEX and perform the appropriate diagnostic procedure.
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to 6F24 TRANSMISSION VERIFICATION TEST .
- With the scan tool, read ABS DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.