Program The BCM (Body Control Module)

2013 Dodge and Ram Dart GTSECTION Program The BCM (Body Control Module)
NOTE:

After installing a brand new BCM, the scan tool will be unable to identify the vehicle. Manual VIN entry into the scan tool must be used to continue scan tool communication.

  1. Turn the ignition on.
  2. With the scan tool, perform the following procedure in the BCM Miscellaneous Functions: Restore BCM PROXI Configuration*.
    NOTE:

    NOTE: The Restore BCM PROXI Configuration uses the VIN and sales code information from DealerCONNECT to reconfigure the vehicle. After running the Restore BCM PROXI Configuration, the scan tool will restart to begin a new diagnostic session with the vehicle.

  3. If instructed by the scan tool, run the following procedure in the BCM Miscellaneous Functions: PROXI Configuration Alignment*.
  4. With the scan tool, perform the following procedure in the RFH Miscellaneous Functions: BCM Replaced*.

* - Denotes that a user message indicating that the scan tool procedure is required may automatically display to the technician during the tool connection process

NOTE:

Customer programmable features in the BCM may need to be reset back to the customers preferred settings.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.