Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Powertrain Control: Removal: 1.4L
2013 Dodge and Ram Dart GTSECTION 1.4L
- Disconnect the battery negative cable.
- Remove the engine cover.
- Disconnect the Powertrain Control Module (PCM) electrical connectors (1 and 2).
- Open the two wire harness retainers (3) and reposition the wire harness.
- Remove the four nuts (1) with ground strap (4) and remove the PCM (2) from the bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.