Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2011NITRO HEAT, 3.7 K, 4WDREPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMS(OCCUPANT CLASSIFICATION MODULE (OCM) - ELECTRICAL DIAGNOSTICS)DTC TROUBLESHOOTINGB1BBD-OCM CURRENT CONFIGURATION TABLE UNPROGRAMMEDSET CONDITION
2011 Dodge and Ram Nitro Heat, 3.7 K, 4WD
Set Condition
2011 Dodge and Ram Nitro Heat, 3.7 K, 4WDSECTION Set Condition
This DTC will set if the Occupant Classification Module (OCM) was received unprogrammed from the supplier, the vehicle line was not identified correctly or if the flash procedure was not completed successfully
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.