Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2011JOURNEY R/T, AWDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSENGINE COOLING SYSTEMENGINEHEATER, ENGINE BLOCKINSTALLATION3.6L ENGINE
2011 Dodge and Ram Journey R/T, AWD
3.6L Engine
2011 Dodge and Ram Journey R/T, AWDSECTION 3.6L Engine
- Clean block core hole and heater seat.
- Insert heater block (1) assembly.
- With block heater seated, tighten screw (2) to 12N.M (106 in.lbs.) to assure a positive seal.
- Install power cord plug to block heater (1).
- Fill cooling system with coolant to the proper level. Refer to STANDARD PROCEDURE .
- Install the A/C compressor. Refer to COMPRESSOR, A/C, INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.